Performance spring pre-loader lets you run a softer spring rate that is pre-loaded at ride height. A pre-loaded spring sees less rate increase as the suspension travels, so the car stays more consistent through the corner.
As an example, a 150 lb./in. spring can be pre-loaded to 400 lbs. at ride height but still only increases at 150 lb./in. as the suspension moves. The entire unit can also be swapped for another unit with a different rate spring pre-installed, allowing spring rate changes without affecting ride height.
Features and Benefits:
Allows a softer spring rate pre-loaded at ride height
Less rate increase as the suspension travels
Swap complete units to change spring rate without affecting ride height
Includes a thrust bearing set
Sized for a 14 Inch tall spring
Fits most shocks
Fitment Notes:
Requires a 3 Inch inside diameter spring
Sized for a 14 Inch tall spring
Fits most shocks and is commonly used on the rear coil-overs
Details:
Spring Height: 14 Inch
Spring Inside Diameter: 3 Inch
Material: Aluminum
Finish: Black Anodized
Includes: Thrust Bearing Set
Note: The unit is typically installed with the slotted inner half towards the shock body. Always check components for possible interference.
Details:
Inside Diameter: 3 Inch
Finish: Anodized
Size: 14 Inch Tall Spring - 3 Inch Inside Diameter
Color: Black
Material: Aluminum
Sold As: Each
Application Notes:
Most Shocks Using A 3 Inch Inside Diameter, 14 Inch Tall Spring
